Wraith32 Loading
Not finished yet and still building. Time is worth more than money these days. OMNIBUS F4 V3 is soldered (except beeper but who needs that anyway). Check out previous post.
And by the way… did you see that OMNIBUS F7 FC on Aribot’s web site? Why do I still run F4?
Wraith32
Airbot is the very first manufacturer with the 35A rated and DSHOT1200 capable BLHeli_32 ESCs.
The potential KISS ESC killer is 32bit based and runs a Cortex-M0 at 48MHz. This should allow the ESCs to be extremely efficient and run motors as smooth as never before. The ESCs are packed with features like auto timing, voltage and current limiting and even telemetry.
Specification
- designed for 35A
- 2-6s capable
- includes current sensor
- small sized with 15*30mm (31mm including signal and GND pads)
- RGB LED inside
The Build
My kwad with the Wraith32 ESCs will be built out of following parts.
- Airbot’s OMNIBUS F4 Pro
- Airbot’s Wraith32 ESCs
- ImpulseRC 5″ Alien Frame
- EMAX RS2205S 2300KV Motors
- HS1177 @ 2.5mm
- Foxeer TM25 Switcher VTX @ TBS Triumph
Follow the BLHeli_32 thread @ RCGroups for more information.
Build In Progress
Quality of the ESCs is very good, as usual for Airbot’s products. The golden plated pads are super easy to solder. I’ll probably turn over the ESCs and solder the motors on the other side because then I don’t have to cross + and – wires on my PDB.
Airbot mentioned that adding some tin to the long pad on the side will increase current capacity so I’ll do that as well.
The Wraith32 ESC are longer than KISS ESCs or Racerstar 30A V2 ESCs and it has to be taken into account (they’re also about 6mm thick). I wanted to make motor wires a bit longer and it’s now a pretty tight fit on the arms. The RGB LED is now on the bottom of the ESCs but it’s easier to connect them to the PDB for me that way.
The FC is soldered and the new BLHeli 31.3.0.1 works well. The ESCs get recognized as “Airbot_Wrait32_ST”. Current Betaflight 3.1.7 does not have the necessary code for the pass through function so the one from RCGroups thread has to be flashed.
I don’t recommend flashing the pre-production ESCs with Airbot_Wraith32_ST_Multi_31_2.Hex. I just bricked my ESC #1.
6″ Explosion Loading
Special Edition Taranis
With custom shell, hall gimbals and detachable Antenna. Get it here!
Just before you guys try to install the new hall gimbals into your Taranis, or try to paint your shell or destroy your TX while doing the Taranis antenna mod. Go to BG and buy yourself the special edition Taranis with all needed mods and just enjoy your hobby.
New Hiking Rig
Magic is in the house 😉
You must be logged in to post a comment.